Opensprinkler programs only water in order of the stations 01-08 and cannot have a program that does stations in order 03,06,01,04 for example. Due to this method used, it is very slow at finding. How do I check the IP address assigned to OpenSprinkler Click button B1, and the IP address will be displayed onto the LCD screen. and use of the WAN IP within the application or by using a VPN. The good thing about having ISY integration and programs turning on the stations is I can water in different order now. OpenSprinkler devices can be discovered by the binding sending requests to every IP on your network. OpenSprinkler - The application allows you to automatically detect and control your. I fixed by renaming the station in open sprinkler without the / and then I had to remove/add the poly for ISY to see.

I think I have seen this before in other node servers but I would suggest to replace the / with whitespace or some other character depending on what the actual reason is. Other thing is I named one of my stations 'Front Lawn/Side Lawn' and ISY does not show this station with the '/' slash character. I have worked around this by putting a wait of 5 seconds between each station on command in ISY program. For more information please visit You can control your device from outside the local network with proper port forwarding and use of the WAN IP within the application or by using a VPN. If I turn on multiple stations too quickly in a program, instead of the open sprinkler queueing them, it seems to have more than one of the stations enabled on simultaneously - sometimes I have seen a couple, other times I have seen four on at once, which is not possible to do normally and it should normally queue them to run after each prior one is finished. squid to communicate with my ASA 5505 which has a dynamic IP address. Since it is winter here up in Canada and cannot actually test it by watering the lawn, I can only test using the web UI response and seems to be working. I have been working on my OpenSprinkler mobile web application and decided to port.

So far it has worked fine as standalone but was surprised to see it in the store here! When I start the OS it says its connecting to the network, but then it shows (button2 press) IP of 0.0.0.0 port 0. I happen to have an OpenSprinkler I purchased a couple years ago when my EZ-Flora died. OpenSprinkler is an open-source, web-based sprinkler timer / irrigation controller.

Opensprinkler ip